5 months ago
edgebootPro New Firmware Release: 1.1.0-edge-pro
Granite edgebootPro device firmware 1.1.0-edge-pro
Release Notes:
- Allow user-defined probe targets for customized Advanced Monitoring telemetry
- Add graceful reboot option to serial console menu to perform remote system reboot without affecting devices plugged into edgebootPro - simply press 0 to initiate a system reboot from the main console menu:
- AI mode logic enhancements for independent actions based on specific ethernet interfaces (ideal for monitoring two wired WAN connections)
- Add ability to clear/renew DHCP leases for LAN interfaces
- Fully automated SIM provisioning and modem initialization across all supported carriers
- Fix LTE signal reporting issue where local LTE is up but portal is displaying down or searching
- Add LTE Survey Tool to scan and report live modem signal quality
- Add additional Kernel USB-serial drivers to support more peripherals
- Enable USB-Serial driver for CH340/341 chipsets to support more USB serial devices
- Add packet sniffer detection to improve security visibility
- Adjust dispatcher rules to prevent LTE egress over inactive interface(s)
- Improve modem info collection by switching from AT to native commands
- Improve interface manager handling to prevent unnecessary flapping between wired and LTE interfaces
- Adjust modem watchdog timers to allow for clean initialization across various LTE providers
- Harden auto-failover logic to expand quantity of ping targets & failure thresholds prior to failing over
- Adjust gateway config from ETH1 in NATLAN mode to prevent routing loops and DNS failures
- Prevent routing to backup interface when failover is disabled in NATLAN mode
- Improve device logging and tune non-critical error messages
- Add safeguards to AI reboot service to prevent excessive reboots
- Implement additional performance monitoring for CPU and memory usage
We recommend updating your devices to 1.1.0–edge-pro for optimal performance and improved reliability.
For eligible devices, a banner will appear as shown below. Click "Apply latest firmware" and you’re all set: